Ticket #877 (closed assessed: not an issue)

Opened 8 years ago

Last modified 8 years ago

MPA Optimization Area closed not working

Reported by: joeb Owned by:
Priority: normal Milestone: Ecopath 6: release 6.2
Component: Ecospace Version:
Severity: major Keywords:
Cc:

Description (last modified by jeroens) (diff)

When running the MPA optimization under the Importance layer mode it seems the the Area closed (min %) and Area close (max %) are not used

  • Load the MPA optimization form.
  • Set the Search type to Importance layer.
  • Make sure there is some kind of an MPA loaded.
  • set Area closed min and max, 5-50.
  • set Step % 5.
  • Iteration 5, make this a small enough number that you can wait for it to run, you can also set the Ecospace run length to something smaller so it runs faster.
  • Run it and wait for the output.
  • In the Map input tab you can see the iteration, as the Area size changes you should be able to tell by the number of MPA cells on the map.
  • From the Results tab you should be able to select the different Area closed(%) for output but it does not seem to work only the default of 20% is available.

Change History

comment:1 Changed 8 years ago by jeroens

  • Description modified (diff)

comment:2 Changed 8 years ago by joeb

  • Status changed from new to closed
  • Resolution set to not an issue

Ok this seems to be working now. I'm not sure if it was broken or I was using it wrong.

Note: See TracTickets for help on using tickets.